Page 1
Midea Ceramic Hob Instruction MODEL : MC-HV848 SAVE THESE INSTRUCTIONS CAREFULLY Read these instructions carefully before using your hob,and keep it carefully. If you follow the instructions, your hob will provide you with many years of good service.
1 Foreword 1.1 Safety Warnings Your safety is important to us. Please read this information before using your cooktop. 1.2 Installation 1.2.1 Electrical Shock Hazard Disconnect the appliance from the mains electricity supply before carrying out any work or maintenance on it. ...
Failure to install the appliance correctly could invalidate any warranty or liability claims. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Switch the cooktop off at the wall before cleaning or maintenance. Failure to follow this advice may result in electrical shock or death. 1.3.2 Health Hazard This appliance complies with electromagnetic safety standards. However, persons with cardiac pacemakers or other electrical implants (such as insulin pumps) must consult with their doctor or implant manufacturer before using this appliance to make sure that their implants will not be...
Page 7
Do not place or leave any magnetisable objects (e.g. credit cards, memory cards) or electronic devices (e.g. computers, MP3 players) near the appliance, as they may be affected by its electromagnetic field. Never use your appliance for warming or heating the room. ...
WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. Keep the appliance and its cord out of reach of children less than 8 years ...
Read this guide, taking special note of the „Safety Warnings‟ section. Remove any protective film that may still be on your ceramic hob. 2.6 Technical Specification Cooking Hob MC-HV848 Cooking Zones 5 Zones Supply Voltage 220-240V~ 50Hz or 60Hz...
3.2 Choosing the right Cookware Do not use cookware with jagged edges or a curved base. Make sure that the base of your pan is smooth, sits flat against the glass, and is the same size as the cooking zone. Always centre your pan on the cooking zone. Always lift pans off the ceramic hob –...
• You can modify the heat setting at any time during cooking. • You can modify the power level from 0 to 9 by the slide Power down control. 3.3.2 Finish cooking Touching the heating zone selection control that you wish to switch off.
3.3.4 Using the Double zone function • The function only work in 3# and 4# cooking zone • The dual cooking zone has two cooking areas that you can use a central section and an outer section. You can use the central section (A) independently or both sections (B) at once. Zone 3# Zone 4# Activate the Double zone...
Page 13
a) Using the Timer as a Minute Minder If you are not selecting any cooking zone Make sure the cooktop is turned on. Note: you can use the minute minder even if you‟re not selecting any cooking zone. Touch the timer control, the “10” will show in the timer display.
set the time by touching the slider control (e.g.9), now the timer you set is 95 minutes. When the time is set, it will begin to count down immediately. The display will show the remaining time When cooking timer expires, the corresponding cooking zone will be switched off automatically.
3.3.7 Residual Heat Warning When the hob has been operating for some time, there will be some residual heat. The letter “ H ”appears to warn you to keep away from it. 3.3.8 Default working times Another safety feature of the hob is automatic shutdown. This occurs whenever you forget to switch off a cooking zone.
3. Preheat the pan briefly and add two tablespoons of oil. 4. Cook any meat first, put it aside and keep warm. 5. Stir-fry the vegetables. When they are hot but still crisp, turn the cooking zone to a lower setting, return the meat to the pan and add your sauce.
Boilovers, melts, and Remove these immediately with a fish • Remove stains left by melts and hot sugary spills on the slice, palette knife or razor blade sugary food or spillovers as soon glass scraper suitable for Ceramic glass as possible. If left to cool on the cooktops, but beware of hot cooking glass, they may be difficult to zone surfaces:...
8 Installation 8.1 Selection of installation equipment Cut out the work surface according to the sizes shown in the drawing. For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole. Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work surface material (Wood and similar fibrous or hygroscopic material shall not be used as work surface material unless impregnated) to avoid the electrical shock and larger deformation caused by the heat radiation from the hotplate.
WARNING: Ensuring Adequate Ventilation Make sure the ceramic hob is well ventilated and that air inlet and outlet are not blocked. In order to avoid accidental touch with the overheating bottom of the hob, or getting unexpectable electric shock during working, it is necessary to put a wooden insert, fixed by screws, at a minimum distance of 50mm from the bottom of the hob.
Adjust the bracket position to suit for different work surface‟s thickness. TABLE TABLE BRACKET BRACKET Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation (see picture). 8.3 Cautions 1. The ceramic cooker hob must be installed by qualified personnel or technicians. We have professionals at your service.
Page 21
Yellow/Green Black Brown Blue 1. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so as to avoid any accidents. 2. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a minimum gap of 3mm between the contacts.
Need help?
Do you have a question about the MC-HV848 and is the answer not in the manual?
Questions and answers