Table of Contents
Advertisement
3.14.5 Model 5824 Installation Instructions
The Model 5824 provides the 5208 with the ability to communicate to a serial or parallel
printer to print the event log. You can use one 5824 on the 5208. The 5824 is for ancillary use
only.
3.14.5.1 Mounting the 5824 Module
The 5824 comes in a plastic enclosure, follow these steps to mount the 5824's plastic
enclosure:
1. Remove the 5824's cover. Use a small screw driver if necessary.
2. Remove the 5824 circuit board from the base by pushing outward on the base snap
retaining tabs and lifting the circuit board out.
3. Mount the plastic base.
4. Replace the circuit board in the plastic base.
Note: It may be necessary to connect the wiring to the circuit board before the board is replaced in the base. See
Section 3.14.5.2.
5. Connect the 5824 to the 5208.
6. Set the device ID (see Section 3.14.1). See also Figure 3-25 for ID selector switch
location.
P/N 151204
Mounting Holes
Mounting Holes
Figure 1: 5824 Circuit Board And Plastic Base
firealarmresources.com
Control Panel Installation
Snap
Retaining Tabs
Base
3-33
Advertisement
Table of Contents
Troubleshooting
