OSEE FRM-173 Series User Manual page 51

Items Default Value Domain Range
GPI2 TALLY RED
GPI3 UNDEF
GPI4 UNDEF
GPI5 UNDEF
GPI6 UNDEF
 Assign functions to GPI1~GPI6, some is level triggered, and some is edge
triggered, refer to Table 5.1-13 for the details.
 GPI control: when it changes it would be as a control value of response
control. If the level does not change, but there are other control caused by
changes in the control value, perform this change. When boot, detect the
GPI input status after initialization. If a GPI value is low, the monitor will
control the corresponding operation. The TALLY is directly control by the
level.
Table 5.1-13 The Description for GPI Items and Their Trigger
Items Function
Enable/Disable the display of
AREA MARKER
area marker.
CENTER
Enable/Disable the display of
MARKER center marker.
SAFETY Enable/Disable the display of
MARKER safety marker.
ASPECT Set the aspect ratio.
Switch
MONO
monochrome and color.
MARKER, ASPECT, NATIVE,
OVER SCAN, UNDER SCAN,
BLUE ONLY, MONO,
DELAY, V DELAY,
DELAY, SDI1, SDI2, LINE1,
LINE2, HDMI,
GREEN, TALLY RED
the same as GPI1
the same as GPI1
the same as GPI1
the same as GPI1
the same as GPI1
between the
45
Functionality of the Main Menu
Description
H/V
TALLY
Set a function to GPI2
Set a function to GPI3
Set a function to GPI4
Set a function to GPI5
Set a function to GPI6
Trigger
Low: Enabled; High: Disabled
Low: Enabled; High: Disabled
Low: Enabled; High: Disabled
Low: 16:9; High: 4:3
Low: MONO; High: NORMAL