Advertisement
Placing the remote
controller
Slide from above
Remote
controller
holder
How to put the dry batteries
(1) Remove the back cover
of the remote controller
to the direction pointed
by the arrow mark.
(2) Put the batteries
Use two dry cell batter-
ies (AAA.LR03 (alka-
line)). Put dry batteries
correctly to fit their (+)
and (–).
(3) Close the cover.
When to change batteries
Under normal use, batteries last about a
year. However, change them whenever the
indoor unit doesn't respond or responds
slowly to commands, or if the display
becomes dark.
[CAUTION]
• Replace all batteries at the same time, do
not use new and old batteries simultane-
ously.
• In case the remote controller is not used
for a long time take out all batteries in
order to prevent liquid leak of the battery.
6
Removing the
remote controller
Pull it upward
IN CASE OF CENTRALIZED
CONTROL SYSTEM
If the indoor unit is under centralized control, it is
necessary to switch the remote controller's set-
ting.
In this case, contact your DAIKIN dealer.
4. Operation range
VRV and Sky Air System
See the operation manual provided with the
air conditioner.
5. Operation procedure
Refer to figure 1 on page [1]
• Operating procedure varies with heat
pump type and cooling only type. Contact
your Daikin dealer to confirm your system
type.
• To protect the unit, turn on the main power
switch 6 hours before operation.
• If the main power supply is turned off
during operation, operation will restart
automatically after the power turns back
on again.
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY
OPERATION
Operate in the following order.
• AUTOMATIC OPERATION can be
selected only by Heat pump split system or
Heat recovery VRV system.
• For cooling only type, "COOLING", and
"FAN" and "DRY" operation are available
to select.
FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE
CONTROL SWITCH
Refer to figure 1-1, 2 on page [1]
OPERATION MODE
MODE
SELECTOR
Press OPERATION MODE SELECTOR
button several times and select the
English
Advertisement
