Advertisement
The displays showing "
indoor units connected to the same outdoor
unit or BS unit will flash.
MODE
Press the OPERATION MODE SELEC-
TOR button to the indoor unit that you
wish to designate as the master remote
controller. Then designation is com-
pleted. This indoor unit is designated
as the master remote controller and
the display showing "
• To change settings, repeat steps
EMERGENCY OPERATION
When the remote controller does not work
due to battery failure or the absence thereof,
use this switch which is located beside the
discharge grille on the main unit. When the
remote controller does not work, but the bat-
tery low indicator on it is not lit, contact your
dealer.
[START]
Press the emergency
operation switch.
The machine runs in the previous mode.
The system operates with the previously set
air flow direction.
[STOP]
Press the EMERGENCY
OPERATION switch again.
English
" of all slave
" vanishes.
1
2
and
.
PRECAUTIONS FOR GROUP
CONTROL SYSTEM OR TWO REMOTE
CONTROLLERS CONTROL SYSTEM
This system provides two other control
systems beside individual control (one
remote controller controls one indoor unit)
system. Confirm the following if your unit is of
the following control system type.
■
Group control system
One remote controller controls up to 16
indoor units.
All indoor units are equally set.
■
Two remote controllers control system
Two remote controllers control one indoor
unit (in case of group control system, one
group of indoor units).
The unit follows individual operation.
NOTE
• Cannot have two remote controller control
system with only wireless remote control-
lers. (It will be a two remote controller con-
trol system having one wired and one
wireless remote controllers.)
• Under two remote controllers control sys-
tem, wireless remote controller cannot
control timer operation.
• During operation of the two controllers
connected the same unit, the wireless
remote controller displays the OPERA-
TION MODE only.
• If the wired remote controller is used for
operation, the display on the wireless
remote controller does not change.
• Only the operating indicator lamp out of 3 other
lamps on the indoor unit display functions.
NOTE
• Contact your Daikin dealer in case of
changing the combination or setting of
group control and two remote controller
control systems.
11
Advertisement
