Advertisement
NOTE
• Stop flaps from swinging before trying to
angle them. Working while the flaps are
moving may get your fingers pinched.
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer
controls the air flow direction so it may be
different from the display.
Operation
Cooling
mode
• When operating
continuously at
downward air
flow direction
Operation
conditions
NOTE
• If you try cooling or programmed drying
while the flaps are facing downward, air
flow direction may change unexpectedly.
There is nothing wrong with the equipment.
This serves to prevent dew formed on parts
in the air discharge outlet from dripping.
• Operation mode includes automatic
operation.
PROGRAM TIMER OPERATION
Operate in the following order.
• The timer is operated in the following two
ways.
Programming the stop time (
.... The system stops operating after the
set time has elapsed.
Programming the start time (
.... The system starts operating after the
set time has elapsed.
• The timer can be programmed a maximum
of 72 hours.
• The start and the stop time can be simulta-
neously programmed.
English
Press the TIMER MODE START/STOP
button several times and select the
mode on the display.
The display flashes.
For setting the timer stop .... "
For setting the timer start .... "
Heating
• When room
temperature is
higher than the
Press the PROGRAMMING TIME but-
set temperature
ton and set the time for stopping or
• At defrost
starting the system.
operation
When this button is pressed, the
(The flaps blow
time setting advances by 1 hour.
horizontally to
avoid blowing
When this button is pressed, the
cold air directly
time setting goes backward by 1
on the occupants
hour.
of the room.)
Press the TIMER RESERVE button.
The timer setting procedure ends.
The display changes from flashing light to a
constant light.
Press the TIMER OFF button to cancel
programming. The display vanishes.
)
)
TIMER MODE
TIMER
START/STOP
PROGRAMMING TIME
UP
DOWN
RESERVE
TIMER RESERVE
CANCEL
TIMER CANCEL
"
"
UP
DOWN
9
Advertisement
