Table of Contents
Advertisement
Figure 48. Removing the M.2 riser
NOTE:
XC Core does not use the SATA cable version.
Next steps
Replace the M.2
riser.
Installing the M.2 riser
Prerequisites
● Follow the safety guidelines listed in
● Follow the procedure listed in
●
Remove the air
shroud.
Steps
1. Align the M.2 riser with the stand off on the system board and insert it firmly until the riser is fully seated in the slot.
2. Using a Phillips #2 screwdriver, tighten the screw that secures the riser to the chassis.
48
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
