Figure 47. Installing the LOM
Next steps
1.
Install the expansion card riser
2. Follow the procedure listed in
M.2 SSD module
Removing the M.2 riser
Prerequisites
● Follow the safety guidelines listed in
● Follow the procedure listed in
●
Remove the air
shroud.
Steps
1. Using a Phillips #2 screwdriver, remove the screw that secures the riser to the chassis.
2. Holding the blue tag, lift the riser to disengage the riser from the connector on the system board.
1.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
47