General Memory Module Installation Guidelines - Dell EMC XC Core XC6520 Installation And Service Manual

Table of Contents

Advertisement

Figure 54. Memory socket location
Table 14. Supported memory matrix
DIMM type Rank
RDIMM
2R
LRDIMM
4R
NOTE:
Mixing of memory module capacities in a system is not supported.

General memory module installation guidelines

To ensure optimal performance of your system, observe the following general guidelines when configuring your system memory.
If your system's memory configurations fail to observe these guidelines, your system might not boot, stop responding during
memory configuration, or operate with reduced memory.
The memory bus may operate at frequency can be 3200 MT/s, 2933 MT/s, or 2666 MT/s depending on the following factors:
● System profile selected (for example, Performance Optimized, or Custom [can be run at high speed or lower])
● Maximum supported DIMM speed of the processors.
● Maximum supported speed of the DIMMs
NOTE:
MT/s indicates DIMM speed in MegaTransfers per second.
The system supports Flexible Memory Configuration, enabling the system to be configured and run in any valid chipset
architectural configuration. The following are the recommended guidelines for installing memory modules:
● All DIMMs must be DDR4.
● RDIMMs and LRDIMMs must not be mixed.
● x4 and x8 DRAM based memory modules can be mixed.
● Up to two RDIMMs can be populated per channel regardless of rank count.
● Up to two LRDIMMs can be populated per channel regardless of rank count.
● A maximum of two different ranked DIMMs can be populated in a channel regardless of rank count.
● If memory modules with different speeds are installed, they will operate at the speed of the slowest installed memory
module(s).
● Populate memory module sockets only if a processor is installed.
○ For single-processor systems, sockets A1 to A8 are available.
○ For dual-processor systems, sockets A1 to A8 and sockets B1 to B8 are available.
● In Optimizer Mode, the DRAM controllers operate independently in the 64-bit mode and provide optimized memory
performance.
54
Installing and removing system components
Capacity
16 GB / 32 GB / 64 GB
128 GB
DIMM rated voltage and speed DIMMs per Channel
DDR4 (1.2V), 3200 MT/s
DDR4 (1.2V), 2666 MT/s
(DPC)
3200 MT/s
2666 MT/s

Advertisement

Table of Contents
loading

Table of Contents