Installing Expansion Card Riser 1 - Dell EMC XC Core XC6520 Installation And Service Manual

Figure 34. Removing the expansion card riser 1
NOTE: TESLA T4 is used for illustrative purposes only.
Next steps
Replace expansion card riser

Installing expansion card riser 1

Prerequisites
NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
● Follow the safety guidelines listed in
● Follow the procedure listed in
● Remove the air shroud.
● If applicable, reconnect the cables.
NOTE: The procedure to install Riser 1A and 1B is same.
Steps
1. Align the screw holes on the riser with the screw holes on the chassis.
2. Lower the riser firmly until the riser card is fully seated in the slot.
3. Using a Phillips #1 screwdriver, tighten the screws that secure the expansion card riser 1 on to the system board.
36 Installing and removing system components
1.
Safety instructions.
Before working inside your system.