Function Setting - Sinclair S-THERM GSH-TRB2+ Series User Manual

2.2 Function Setting

[Operation Instructions]
1.At the menu page, by touching "FUNCTION", it will go to the function setting page as shown in the figure
below.
2.At the function setting page, by touching the page turning key, it will access to the last or next page. When
setting is finished, by touching the menu page icon, it will directly back to the menu page; by touching the back
icon, it will back to the upper menu.
3.At the function setting page, by pressing the desired function, it will access to the corresponding setting page
of this option.
4.At the function setting page of some function option, by touching "OK", this setting will be saved; by touching
the "CANCEL" key, this setting will be canceled.
[Notes]
●At the function setting page with setting of any function changed, if the function is set to be memorized upon
power failure, this setting will be saved automatically and memorized upon next power-on.
●When there is submenu for the selected function option, by pressing it the control will go directly the setting
page of the submenu.
●"NA" will be displayed for unavailable functions of the heating only units and mini chillers. When setting these
functions, the controller will tell setting of this parameter is unallowed.
No Item
1 Mode
FUNCTION Setting Page
Function Setting
Range Default
Cool
Heat
Hot water
Cool + Hot water
Heat + Hot water
ON Page
1. When the water tank is unavailable, then only
"Cool" and "Heat" are available.
2. For the heating only unit, only "Heat" mode, "Hot
Heat
water", and "Heat + hot water" are available.
3. It is defaulted to be "Heat" for the heat pumps and
heating only units and "Cool" for mini chillers.
5
Remarks