Lamp Replacement - Christie 103-008100-01 User Manual

APPENDIX
When the projection lamp of this projector reaches its end of
life, the LAMP REPLACE indicator lights yellow. If this
indicator lights yellow, replace the projection lamp with a new
one promptly.
CAUTION
Allow the projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
Follow these steps to replace lamp assembly.
1
Turn off the projector and unplug the AC power cord. Allow
the projector to cool for at least 45 minutes.
2
Loosen the two (2) screws with a screwdriver and open the
lamp cover.
3
Loosen the two (2) screws with a screwdriver and pull out the
lamp assembly by using the built in handle.
4
Replace the lamp assembly with a new one and tighten the
two (2) screws. Make sure that the lamp assembly is set
properly. Put back the lamp cover and tighten the two (2)
screws.
5
Connect the AC power cord to the projector and turn on the
projector.
6
Reset the Lamp replacement counter (refer to"LAMP
REPLACE COUNTER" on the next page).
NOTE:
• Do not reset the Lamp replacement counter when the projection lamp is not
replaced.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No. of your projector
●
Replacement Lamp Type No.
48

LAMP REPLACEMENT

This indicator lights yellow
when the projection lamp
reaches its end of life.
Replace the projection lamp
with a new one promptly.
For continued safety, replace with a lamp
assembly of the same type.
Do not drop the lamp assembly or touch a glass
bulb! The glass can shatter and may cause injury.
: 103-008100-01
: 003-120188-01
(Service Parts No. 610 328 7362)
TOP CONTROL
CAUTION
LAMP
ASSEMBLY
LAMP COVER
HANDLE