Quiet Operation (Heating); Powerful Mode Operation; Timer Control - Panasonic CS-Z35UFRAW Service Manual


Control contents
Fan speed is changed from normal setting to quiet setting of respective fan speed.
o
Fan speed for quiet operation is reduced from setting fan speed.

14.6 Quiet Operation (Heating)


Purpose
To provide quiet heating operation compare to normal operation.
o

Control condition
Quiet operation start condition
o
 When "QUIET" button at remote control is pressed.
QUIET LED illuminates.
Quiet operation stop condition
o
 When one of the following conditions is satisfied, quiet operation stops:

QUIET button is pressed again.

Stop by OFF/ON switch.

Timer "off" activates.
 When quiet operation is stopped, operation is shifted to normal operation with previous setting.
 When fan speed is changed, quiet operation is shifted to quiet operation of the new fan speed.
 When operation mode is changed, quiet operation is shifted to quiet operation of the new mode, except
fan mode only.
 During quiet operation, if timer "on" activates, quiet operation maintains.
 After off, when on back, quiet operation is not memorised.

Control contents
Fan speed manual
o
 Fan speed is changed from normal setting to quiet setting of respective fan speed.
 Fan speed for quiet operation is reduced from setting fan speed.
Fan Speed Auto
o
 Indoor FM RPM depends on pipe temp sensor of indoor heat exchanger.

14.7 Powerful Mode Operation


When the powerful mode is selected, the internal setting temperature will shift lower up to 2.0°C (for Cooling/Soft
Dry) or higher up to 3.5°C (for Heating) than remote control setting temperature for 20 minutes to achieve the
setting temperature quickly.

14.8 Timer Control


There are 2 sets of ON and OFF timer available to turn the unit ON or OFF at different preset time.

If more than one timer had been set, the upcoming timer will be displayed and will activate in sequence.
14.8.1 ON Timer Control

ON timer 1 and ON timer 2 can be set using remote control, the unit with timer set will start operate earlier than
the setting time.
This is to provide a comfortable environment when reaching the set ON time.

60 minutes before the set time, indoor (at fan speed of Lo-) and outdoor fan motor start operate for 30 seconds to
determine the indoor intake air temperature and outdoor air temperature in order to judge the operation starting
time.

From the above judgment, the decided operation will start operate earlier than the set time as shown below.
76