Volt Electronic Ignition System Connection Diagrams - Warming Trends CFBL170 NG Owner's Manual And Instruction Manual

24 VOLT ELECTRONIC IGNITION SYSTEM
CONNECTION DIAGRAMS
250K — 300K+ BTU Systems
1. Locate FK2
Parts include two Whistle-Free Flex Lines, key valve,
escutcheon plate, and keys.
3" Key
STEP 1- FIT250
(2) 3/4" x 3" Nipple,
(2) 3/4" Tees
(1) 3/4" x ½" MM Reducer Fitting
YOUR INSTALLATION MAY NOT REQUIRE ALL PARTS.
2. Remove Flared Fittings from Whistle-Free Flex Lines
(FK2) Removing flared fittings first makes attaching to the
3/4" Tees easier.
Thread
sealant is
applied
to this
end only
throughout
instructions
3. Connect to Coupling
(FK2) Do not use 2nd 3/4" x 3" Nipple with this install.
Connect ½" x 3/4" Reducing Fitting to Gas Valve.
Coupling
Drip 24 Volt Ignition
Leg
16
12" Key
Escutcheon
Flared End
Flared Fitting
Plate
½" x 3/4" Reduc-
ing Fitting
Apply thread
sealant here
www.Warming-Trends.com | 303 346 2224 | orders@warming-trends.com
Key Valve
3A. Connect to Coupling
(FK2) Do not use 1/2" x 3/4" reducer fitting with
this install. Connect 3/4" x 3" Nipple to Gas Valve.
Coupling
Drip 24 Volt Ignition
Leg
Whistle-Free Flex Lines
Flared
Fitting
Whistle-Free Flex Line
Plate
3/4" x 3" Nipple
Apply thread
sealant here