[Camera] > [Panorama] Creating A Panorama Image; Creating A Panorama Image - Canon 2541C001 Operation Manual

[Camera] > [Panorama]

Creating a Panorama Image

You can create a panorama image that captures the entire area that can be captured by the camera.
Created panorama images are displayed in the Viewer and part of the Setting Page.
Important
• If you change the privacy mask settings in [Privacy Mask], it is recommended that you create the panorama image again to reflect the
new privacy mask settings in the panorama image.
• If you have changed the camera installation method settings, recapture the panorama image.
Creating a Panorama Image
A panorama image can be used in the Viewer and for a privacy mask by clicking [Apply] to save it to the camera after
capturing.
Note
• While a panorama image is being captured, the Image Stabilizer is temporarily disabled.
• The following users will be disconnected while creating a panorama image.
– All users except for administrators
– Users not connected via RTP
• When a small value is entered for [Maximum Frame Rate: Video Transmission] (P. 92) in [Video] > [JPEG], panorama capture is slowed
down.
Set [Panorama Creation Area].
1
Set the range for panorama creation. This enables the panorama creation time to be reduced.
[Specify the panorama creation area]
If you select [Specified], the panorama image is created within a set area that can be captured by the camera. If
you select [Not Specified], the panorama image is created within the entire area that can be captured by the
camera.
If you selected [Not Specified], proceed to step 3.
110
The following settings can be configured here.
• Panorama Creation Area
• Panorama Image
• Capture Settings
HM4x
HM4x S30 S31