Table of Contents
Advertisement
Index of Parts and Functionos
Rear panel
9
1 REMOTE terminal
Terminal for controlling the monitor by an external control (
2 Y / Pb / Pr (IN) terminals (BNC)
3 CVBS terminals (BNC)
Input (IN) and output (OUT) terminals for the composite signals.
4 VGA-IN (mini D-sub 15pin)
Input terminal for analog RGB signal. ( page
5 HDMI terminal
Input / Output terminal for HDMI signals. The monitor will not display or output HDMI with HDCP protection. (
6 E. AUDIO 3G/HD/SD SDI (IN 1, IN 2) terminals (BNC)
Input / Output terminals for the HD/SD SDI signals.
The terminals accept also EMBEDDED AUDIO signals including up to 16 audio channels with a sampling frequency of 48 kHz.
7 AUDIO (IN) terminals (pin jack)
Input terminals for the analog audio signals.
Set signal source as ANALOG (CVBS, VGA, YPbPr) ,the analog audio can be monitored as audio meters or output via Speaker/Headphone.
8 USB socket
9 DC-IN terminal
Main (Back up) power input, connect with DC11V 17V 4-pin XLR power adapter. (Pin 1: Negative, Pin 4: Positive)
10 AC-IN terminal
AC power input connector.
Connect the provided AC power cord to an AC outlet.
CAUTION
Do not connect the power cord until all other connections are completed.
Note for connections
•
•
Use a cord whose plugs correctly match the terminals on this monitor and the equipment.
•
•
When unplugging a cord, be sure to grasp its plug and pull it out.
•
DO NOT connect the power cord until all connections are complete.
•
Refer also to the user manual of each piece of equipment.
1
0
"External Control" on page 17
22
)
IN
Y
1
RS-485
2
OUT
Pb
Pr
GPI
OUT
IN
3
CVBS
RS-232C
VGA-IN
4
1
OUT
IN
5
HDMI
OUT1
IN1
6
OUT2
IN2
3G/HD/SD-SDI
R
L
7
AUDIO-IN
Firmware upgrade
8
USB
).
page 22)
7
Advertisement
Table of Contents
