Honeywell T775B Series Instruction Instructions page 28

T775A/B/M SERIES 2000 CONTROLLER
SETUP
OUTPUTS
FLOAT 1
DERIVATIV
Fig. 65. Setup - Outputs - Floating Relay - Derivative.
SETUP
OUTPUTS
RELAY 1
SCHEDULE
Fig. 66. Setup - Outputs - Relay - Schedule.
SETUP
OUTPUTS
RELAY 1
RESET RT
Fig. 67. Setup - Outputs - Relay - Reset Runtime.
62-0254–03
SETUP
OUTPUTS
FLOAT 1
DERIVATIV
0
SEC
ENTER
DERIVATIVE
TIME FOR
FLOAT 1
M24531
SETUP
OUTPUTS
RELAY 1
SCHEDULE
YES
NO
USE
SCHEDULE
FOR
OUTPUTS
M24532
SETUP
OUTPUTS
RELAY 1
RESET RT
YES
NO
RESET
RUN TIME
FOR
RELAY 1
M24533
2. SETUP (ADVANCED OPTIONS)
2.3.4.1.1.3. DERIVATIVE
The Derivative option displays only on the T775B2016,
T775B2024, T775B2032, and T775B2040 models when
the Type option = Floating.
1. From the menu, use the
light DERIVATIV.
2. Press the button to display the actuator value.
3. Use the and
desired number of seconds.
Default: 0 seconds
Range: 0 to 3,600 seconds)
4. Press the button to accept the value and display
the SCHEDULE option.
Continue with "2.3.4.2. SCHEDULE" for the remaining
relay selections.
2.3.4.2. SCHEDULE
This selection displays only if "Use Sched = YES" is
selected during the Output Options setup (see page 24).
When selected, individual outputs default to follow the
schedule.
1. Press the button to display the Schedule values.
2. Use the and
Default: YES
3. Press the button to accept the value and return to
the Relay menu.
An individual output can be selected to be controlled or
not controlled by the schedule.
If NO is selected, the Setback selection does not appear
in the Program menu for this output.
2.3.4.3. RESET RT
(run time hours)
This selection displays only if "Show RT = YES" is
selected during Output Options setup (see page 25).
1. From the Relay menu, press the
the Reset RT values.
2. Use the and
Default: NO
3. Press the button to accept the value and return to
the Relay menu.
Selecting YES immediately resets the output run time
hours to zero for this output. When you subsequently
return to this screen, the RESET RT defaults to NO.
NOTE: Run times can be reset to zero for each individ-
ual relay. You must do this for each relay that
you want to reset to zero.
28
(modulating/floating relay only)
and buttons to high-
buttons to increase/decrease the
buttons to select YES or NO.
button to display
buttons to select YES or NO.