Honeywell T775B Series Instruction Instructions page 23

2. SETUP (ADVANCED OPTIONS)
SETUP
OUTPUTS
MOD 1
DERIVATIV
Fig. 50. Setup - Outputs - Mod Out - Derivative.
SETUP
OUTPUTS
MOD 1
SCHEDULE
Fig. 51. Setup - Outputs - Mod Out - Schedule.
Fig. 52. Setup - Outputs - Mod Out - Exit.
SETUP
OUTPUTS
MOD 1
DERIVATIV
0
SEC
ENTER
DERIVATIVE
TIME FOR
MOD 1
M24516
SETUP
OUTPUTS
MOD 1
SCHEDULE
YES
NO
USE
SCHEDULE
FOR
OUTPUTS
M24517
SETUP
OUTPUTS
MOD 1
TYPE
MIN OUT %
INTEGRAL
DERIVATIV
SCHEDULE
EXIT
M24518
T775A/B/M SERIES 2000 CONTROLLER
2.3.1.4. DERIVATIVE
The Derivative default value is factory set to zero (no
derivative control). It is strongly recommended that the
derivative remain at zero (0) unless you have a very good
reason to adjust it. Derivative control is not needed in the
vast majority of HVAC applications.
1. From the Mod menu, use the
highlight DERIVATIV.
2. Press the button to display the Derivative sec-
onds.
3. Use the and
value.
Default: 0 (zero)
Range: 0 to 3,600 seconds
4. Press the button to accept the seconds and
return to the Mod menu.
2.3.1.5. SCHEDULE
The Schedule option displays only if the USE SCHED
parameter is set to Yes (see page 24).
1. From the Mod menu, use the
highlight SCHEDULE.
2. Use the and
Default: YES
3. Press the button to accept the selection and
return to the Mod menu.
Each output can be set up to follow or ignore the built in
scheduler. To disable the scheduler for all outputs, see
"2.3.3.1. USE SCHED" on page 24.
2.3.1.6. EXIT
Press the button (or highlight EXIT and press the
button) to exit the Mod menu and return to the Outputs
menu.
If you have a second modulating output to configure, go to
"2.3.1. Setting up the Modulating Outputs" on page 21.
If you are finished setting up the modulating outputs,
continue with "2.3.2. NBR OF RELAYS".
23
and buttons to
buttons to increase/decrease the
and buttons to
buttons to highlight YES or NO.
62-0254–03