Buffalo TeraStation WSS 5000R2 User Manual page 37

7
Close the front cover with the included key. Press the power button on the TeraStation to turn it on.
Note: If drive 1 is being replaced, the red error LED will light up and "POST ERR: 00D9 Boot from HDD x" will be
displayed on the LCD panel. Wait for the unit to reboot. When the reboot is finished, go on to step 8.
8
Open NAS Navigator2 by double-clicking the
9
Right-click on your TeraStation's icon and click Open Remote Desktop. For Mac, click the TeraStation icon while
holding down the control key and click Open Remote Desktop.
10
Enter the username and password and press Enter key. Windows Storage Server opens in the remote desktop.
Note: The default username and password are "Administrator" and "password".
11
Click RAID Builder from the Start menu of Windows Storage Server.
12
Select Repair the mirrored volume of the system area, check replaced hard drive, and click OK.
13
When "When Drive X will be initialized. Continue?" is displayed, click OK. It will take about an hour for the mirrored
volume to be repaired. You can check the progress of the repair in "Disk Management".
14
In Windows Storage Server, open Administrative Tools and double-click Computer Management.
15
Click Disk Management.
16
Select the step depending on your purpose for a created volume.
To create a new volume:
(1) Right-click the new dynamic disk and select New Volume. (2) Follow the instructions on the screen to create a
new volume.
To restore a RAID 5 volume (RAID resynchronization):
(1) Right-click the volume labeled "Failed Redundancy" and click Restore Volume. (2) When "Select the disk from the
icon.
37