Connecting Rgb - HP LD4201 User Manual

Connecting RGB

1. For analog operation, connect the D-Sub signal cable to the RGB IN (1) connector on the rear of
the display and the other end to the connector (2) on the media player/computer.
NOTE:
included.
Figure 3-26
2.
Connect the audio cable (sold separately) to the Audio (RGB/DVI) (1) connector on the rear of the
display and the other end to the Line Out port (2) on the media player/computer if the video
signal connection is from either a RGB (VGA) or DVI connector on the media player/computer.
Figure 3-27
1
3.
Select an input signal:
Press the INPUT button on the remote control, select the RGB input signal, and then press the OK
button to save.
Or, press the
the AUTO/SET
22 Chapter 3 Setting up the display
If connecting to a Mac media player/computer, use the standard Mac adapter (3)–not
Connecting the D-Sub signal cable
1
Connecting the audio cable
button on the back of the display, select the RGB input signal, and then press
INPUT
button to save.
2
3
2
ENWW