Using The Auto-Adjustment Function (Rgb Input Source Only); Using The On-Screen Display Menu - HP LD4201 User Manual

Using the auto-adjustment function (RGB INPUT
source only)
You can optimize the screen performance by using the
on the remote control) and the Auto-adjustment Pattern Utility software on the CD provided.
NOTE: Do not use this procedure if the display is set to use a DisplayPort or HDMI/DVI input source.
If the display is using a PC analog signal input, this procedure can correct the following image quality
conditions:
Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An off-center picture
●
To use the auto-adjustment feature:
1.
Allow the display to warm up for 20 minutes before adjusting.
2. Press the
If the result is not satisfactory, continue with the procedure.
3. Insert the CD in the disc drive. The CD menu appears.
4. Select Open auto-adjustment software. The setup test pattern appears.
5. Press the
6.
Press the

Using the On-Screen Display menu

The display settings can be adjusted from the On-Screen Display (OSD) menu.
Icon
30 Chapter 4 Operating the display
AUTO/SET button.
AUTO/SET button to produce a stable, centered image.
ESC key or any other key on the keyboard to exit the test pattern.
Main menu
Picture
Audio
Time
Option
AUTO/SET
Function description
Set or change Video characteristics such as aspect ratio, brightness, contrast,
energy savings, picture mode, and screen options
Set or change the audio options
Set or change the timer options
Set or change display options such as OSD language, network setup, led lights
on/off, control button lock, power management, DDC-CI, and ISM Method
button on the display (AUTO button
ENWW