Labels - Billy Goat PLUGR Owner's Manual

Warning Labels
The labels shown below were installed on your BILLY GOAT® Aerator. If any labels are damaged or
missing, replace them before operating this equipment. Item numbers from the Illustrated Parts List and part
numbers are provided for convenience in ordering replacement labels. The correct position for each label may
be determined by referring to the Figure and Item numbers shown.
Fig. 1
DANGER KEEP HANDS
AND FEET AWAY
P/N 440424
Instruction Labels
PULL TO ENGAGE TINES
JALE HACIA ARRIBA PARA ENGRANAR LOS DIENTES
Fig. 5
LABEL TINE ENGAGE PL
Engine Labels - Honda
Engine Labels - Vanguard
Part No. 382510
DANGER
PINCH
POINT
100355
Fig. 2
LABEL PINCH POINT PLP/N
100355
FORWARD TO LOWER TINES
BACK TO RAISE TINES
AVANCE PARA BAJAR LOS DIENTES
100356
Fig. 3
DECAL, WARNING, HAND IN BELT,
ENG. ONLY P/N 5103184
100357
Fig. 6
LABEL LOWER TINES PL
4
CHECK OIL BEFORE EACH USE.
GREASE ALL FITTINGS EVERY 10 HOURS OF OPERATION.
WE RECOMMEND ALMAGARD #3752 GREASE FROM R
R
LUBRICATION ENGINEERS INC.
TO AERATE
1. Retract Tines With Center Control Lever.
2. Begin Forward Motion of Aerator Manually.
3. Engage Drive Lever With Aerator Already in Motion.
Fig. 4
LABEL AERATING INST PL
382510_B_HI
100354