Billy Goat PLUGR Owner's Manual page 17

Maintenance
4. Remove the anchor from the old plate. See the part to remove circled in Figure AH. Hold the anchor in
place with pliers and simultaneously use a 1/2" wrench to detach the bottom nut. Attach the anchor to the
new plate.
Figure AG
5. Attach the new plate. Slowly feed the new plate onto the tines. Note the position of the plate. The plate
edge closest to the tine holes should face the operator. See Figure AI.
Figure AI
6. Reverse step 3 to secure the new plate to the engagement cable. Reverse stelp 2 to secure the new
plate to the tine arms.
Part No. 382510 382510_B_HI
17