Billy Goat PLUGR Owner's Manual page 12

Maintenance
6. Reverse steps 1-4 to reattach the top belt-guide-bolt, tineshaft, and hood.
REPLACING THE CLUTCH CABLE
1. Remove the hood of the PL1801 machine. Refer to Step 1 from the "REPLACING THE DRIVE BELT"
section.
2. Remove the clutch idler pivot bolt. Simultaneously use the 1/4" curved Allen wrench with the impact
wrench fitted with a 9/6" socket. See Figures P and Q.
Figure P Figure Q
3. Detach the broken or worn cable from the idler bracket. Use pliers to remove the rue ring from the clevis
pin holding the cable in place. Slide the cable off the clevis pin. Do not discard the clevis pin or rue ring.
You will need these to attach the new cable. See Figures R and S.
Figure R Figure S
Part No. 382510 382510_B_HI
12