Billy Goat PLUGR Owner's Manual page 13

Maintenance
4. Slide the clutch cable out of the machine through the back and unhook the cable from the bail. See
Figures T and U.
Figure T Figure U
5. Attach the new cable to the bail and route the cable through the back of the machine. Reverse step 3
to attach and secure the new cable to the idler bracket. Reverse step 2 to secure the idler bracket to the
machine. Engage the cable to ensure proper function then put the hood back onto your PL1801 unit.
REPLACING ISO MOUNT BUSHINGS
1. Remove the hood of the PL1801 machine. Refer to Step 1 from the "REPLACING THE DRIVE BELT"
section.
2. Move the chain link handle lock up for better maneuverability. See Figure V.
Figure V
Part No. 382510 382510_B_HI
13