Table of Contents
Advertisement
Figure 49. Removing the air shroud
Next steps
1.
Install the air
shroud.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in
2. If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing
bracket.
Steps
1. Align the tabs on the air shroud with the securing slots on the chassis.
a. Guide on the air shroud with the guide pin on the system board.
b. Align the intrusion switch with the intrusion switch connector on the system board.
2. Lower the air shroud into the chassis until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
3.
NOTE:
The procedure to install the cooling fan into the air shroud is similar to installing a cooling fan.
If removed,
install the fans into the air
92
Installing and removing system components
Safety instructions
on page 66.
shroud.
Advertisement
Table of Contents
