Table of Contents
Advertisement
Figure 90. Installing optional IDSDM/vFlash module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Follow the procedure listed in
Backplane
Backplane connectors
Depending on the configuration, your system supports one of the following:
● 8 x 3.5 inch SAS/SATA backplane
● 18 x 3.5 inch SAS/SATA backplane
● 8 x 2.5 inch Dell PowerEdge Express Flash (NVMe) backplane
● 16 x 2.5 inch SAS/SATA backplane with the optional additional backplanes below:
○ 8 x 2.5 inch NVMe backplane
○ 16 x 2.5 inch SAS/SATA backplane (FlexBay)
● 32 x 2.5 inch SAS/SATA backplane
138
Installing and removing system components
After working inside your system
on page 67.
Advertisement
Table of Contents
