Level & Stable; Leg & Caster Installation; Changing Pan Height; Shelf Installation Instructions - Delfield UC4048P Specifications, Installation, Operation & Maintenance Manual

Section 2
Level & Stable
After the cabinet has been placed in the desired location,
cabinets with legs must be leveled. Level units from front to
back and from side to side. Leveling will insure proper door
operation and removal of condensate. It is very important
that all legs are properly adjusted to keep the cabinet level,
evenly distribute the weight and to make sure the unit will
not rock, lean or be unstable.
Cabinets with casters must have the caster brake set so the
cabinet cannot move.
Leg & Caster Installation
Legs or casters must be installed and the legs or casters
must be screwed in completely to prevent bending. When
casters are installed the mass of this unit will allow it to
move uncontrolled on an inclined surface. These units
must be tethered/secured to comply with all applicable
codes.
n
The unit must be installed in a stable condition with
the front wheels locked. Locking the front casters after
installation is the owner's and operator's responsibility.
n
Use a jack to lift the refrigeration unit off the ground
just far enough to remove the leg/caster. Place blocking
underneath the unit. Do not work underneath a raised
unit without proper blocking. Do not lift the unit more
than necessary to remove the leg/caster. Lifting the unit
too far can make the unit unstable.
,
All single-section units require that the swivel casters be
mounted on the front and rigid casters be mounted on
the rear.
Part Number: 9295093A 02/21
DANGER
Warning
Warning
Caution

Changing Pan Height

If additional pan temperature cooling ability is desired,
especially in higher ambient temperature conditions and/
or if pan covers are open or off for extended time periods
improved cooling of pans can usually be achieved by utilizing
the lower position of the dual level pan guides.
When utilizing the lower position on a model with drawers,
only 4" deep pans can be used in the top. When utilizing the
lower position on a door model, 4" or 6" deep pans may be
used.
1. Remove all pans, pan dividers, front and rear support bars.
2. Remove the upper side support brackets by pulling them
up and off.
3. Reinstall all components removed in step one.
Use side support alone
to lower pans 1"
If the lower pan position is desired for models 4427N-8 or
4427N-12M, model specific brackets must be ordered. They
will replace all other brackets.

Shelf Installation Instructions

1. Notice the shelves have four alignment pins on the
underside and a backstop on the top back.
2. Insert the shelves into the cabinet.
• The backstop should be at the top back.
• The alignment pins should be in front and back of the
shelf supports.
Installation
Remove upper side
support bracket
Back of unit
13