C. Maintenance Tasks – Qualified
Service Technician
The following tasks must be performed by a
qualified service technician.
NOTICE: Soot may accumulate on the pilot
assembly and the area above the firebox opening.
Periodic cleaning may be required.
Burner Ignition and Operation
Frequency: Annually
By: Qualified Service Technician
Tools needed: Protective gloves, vacuum cleaner,
whisk broom, flashlight, voltmeter, indexed drill
set and a manometer.
12
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Lanai 48/60 Owner's Manual • 4111-900 Rev. C • 06/21
•
Check for smooth lighting and ignition
carryover to all ports. Verify that there is no
ignition delay.
•
Inspect for lifting or other flame problems.
•
Verify manifold and inlet pressures. Adjust
regulator as required.
•
Inspect pilot flame pattern and strength. Clean
or replace orifice spud as necessary.
•
Inspect pilot flame sensing rod for soot,
corrosion and deterioration. Polish with fine
steel wool or replace as required.
•
Verify that there is not a short in flame sense
circuit by checking continuity between pilot
hood and flame sensing rod. Replace pilot as
necessary.