Power Connector Cable - HP Pavilion DV6-3030 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Accessory cover (see
b. Keyboard (see
c. Top cover (see
d. Display assembly (see
Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Release the power cable from the clips (2) built into the base enclosure.
3. Remove the Phillips PM2.5×4.0 screw (3) that secures the power connector to the base enclosure.
4. Remove the power connector bracket (4) The power connector bracket is included with the base
enclosure spare part kit, spare part number 603689-001.
ENWW
Battery on page 43), and then remove the following components:
Hard drive on page
Keyboard on page 54)
Top cover on page 57)
Display assembly on page
44)
66)
Component replacement procedures
Spare part number
603692-001
75