Billion BiPAC 6200WZL R2 User Manual page 79

PIN: PIN stands for Personal Identification Number. A PIN code is a numeric value used in certain
systems as a password to gain access, and authentication. In mobile phones a PIN code locks the
SIM card until you enter the correct code. If you enter the PIN code incorrectly into the phone 3 times
in a row, then the SIM card will be blocked and a PUK code will be required from your network / service
provider to unlock it.
Note: If you enter an incorrect PIN code three times in a row, your SIM card will be blocked. In this
case, please enter your PUK code (it can be supplied by your service provider) and then re-enter your
PIN.
Connection:
•
Always On: The router will make UMTS/GPRS call when starting up. Enabling Always On,
will give you an option of Keep Alive.
•
Connect on Demand: If you want to make UMTS/GPRS call only when there is a packet re-
questing access to the Internet (i.e. when a program on your computer attempts to access the
Internet). In this mode, you must set Idle Timeout value at same time. Enabling Connect on
Demand will give you an option of Idle Timeout.
Idle Timeout: Auto-disconnect the connection when there is no activity on this call for a
predetermined period of time. The default value is 10 seconds.
Obtain DNS Automatically: Select this checkbox to use DNS.
Primary DNS/ Secondary DNS: Enter the IP addresses of the DNS servers. The DNS servers are
passed to the DHCP clients along with the IP address and the subnet mask.
Note: If you don't know how to set these values and please keep them untouched.
75