Table of Contents
Advertisement
BUF12800EVM Software Overview
When JMP6 and the software are set as shown in
6.2.2
Measuring the Power Supply
You must measure the power supply (V
it in the Vsup field located in the top section of the software interface as shown in
The voltage out of each DAC is calculated according to the V
Changing the value in the channel 6 cell as shown below, for instance, immediately changes the output of
channel 6 to 0.996 V. The calculation is performed according to
V x Code_in_decimal
V
=
S
DAC_CHANNEL
18
BUF12800EVM Evaluation Board and Software Tutorial
Figure 16. JMP6 Setting for Logic '1'
) with respect to the GND on the BUF12800 Test Board and enter
S
Figure 17. Measuring and Entering Power-Supply Voltage
1024
Copyright © 2011–2016, Texas Instruments Incorporated
2
Figure
16, the second I
C address can be configured.
value entered.
S
Equation
3.
SBOU116A – September 2011 – Revised August 2016
www.ti.com
Figure
17.
(3)
Submit Documentation Feedback
Advertisement
Table of Contents
