Table of Contents
Advertisement
BUF12800EVM Hardware
3.5
Connecting the USB Cable to the USB DIG Platform
Once power is connected, the USB cable must be connected to the DIG, as shown in
Figure 6. Connecting the USB Cable to the USB DIG Platform
Note that the Test Board and USB DIG Platform must be powered on before connecting the USB cable.
Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog. The popup
window typically changes to Found New Hardware, USB Human Interface Device. This pop-up window
indicates that the device is ready to be used. The USB DIG Platform uses the human interface device
drivers that are part of the Microsoft
In some cases, the Windows Add Hardware wizard is shown. If this prompt appears, allow the system
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
Figure 7. Confirmation of USB DIG Platform Driver Installation
8
BUF12800EVM Evaluation Board and Software Tutorial
Windows
operating system.
®
®
Copyright © 2011–2016, Texas Instruments Incorporated
Figure
Figure
7.
SBOU116A – September 2011 – Revised August 2016
Submit Documentation Feedback
www.ti.com
6.
Advertisement
Table of Contents
