Table of Contents
Advertisement
Telephone Helpline: 1300225960
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
•
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the appliance. Sharp edges can cut.
•
A POLAR agent or qualified technician must carry out repairs if required.
Cleaning the Condenser Filter
•
The condenser is part of the refrigeration system. The
condenser filter requires monthly cleaning.
•
Always disconnect power supply before carrying out Routine
Maintenance.
•
Failure to clean the condenser filter will reduce the
performance and life of your Polar unit and may invalidate
your warranty.
•
These models have a removable filter which can be cleaned
with a vacuum cleaner.
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
The appliance is
leaking water
FA854-A to FA857-A_DA680-A_AB090-A_A5_v1_20210616.indb 5
FA854-A to FA857-A_DA680-A_AB090-A_A5_v1_20210616.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Power supply
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is not properly
levelled
The discharge outlet is blocked
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Check power supply
Defrost the appliance
Clean the Condenser
Check doors are shut and seals are not
damaged
Move the appliance to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
AU
AU
5
2021/6/16 17:28
2021/6/16 17:28
Advertisement
Table of Contents
