Operation - Polar Electro FA854-A Instruction Manual

AU
Fit Glass Panels (for AB090-A only)
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the
collar for the grub screw faces
inwards.
2. Slot the two side panels into the collars, with
the holes in the glass at the top.
Note: Ensure the screw hole
furthest from the edge of the
panel goes to the back of the
appliance.
3. Screw a grub screw into each collar to secure
the panels.
Note: Ensure the soft end of the grub screw
is the end making contact with the glass.
Do not over-tighten the grub screws as it
will result in the glass breaking.
4. Slot the rear panel into the collars, with the
holes in the glass at the top.
5. Screw a grub screw into each collar to secure
the panel.
6. Slot the plastic plugs into each of the holes.
7. Screw the brackets to the inside of each pane
using the bolt assemblies.
Note: Ensure the short end of the bolt
assembly is on the outside of the panels.
8. Place the top panel onto the brackets, ensuring
all holes line up.
9. Insert the plugs and attach the top panel to
the brackets with the bolt assembly.
Bracket
Glass Panel
Bolt Assembly
Plug
Bolt Assembly
4
FA854-A to FA857-A_DA680-A_AB090-A_A5_v1_20210616.indb 4 FA854-A to FA857-A_DA680-A_AB090-A_A5_v1_20210616.indb 4
Telephone Helpline: 1300225960

Operation

Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Ensure gastronorm bays are full at all times,
even if the gastronorms are unused or empty.
Empty bays will greatly reduce efficiency of the
appliance.
• Use the spacer bars provided to fill any gaps
(they are not required to support each GN
pans).
• Do not obstruct the fans inside the appliance.
• Always cover the pan with lid when not in use.
• Do not place hot food or liquid inside the
appliance.
Note: The appliance is not intended for the
long term storage of food.
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the power switch [I]. The current
temperature within the appliance is displayed.
Set the Operating Temperature
1. Press the SET button for 3 seconds. The
display will flash.
2. Press the or buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
2021/6/16 17:28 2021/6/16 17:28