Operation; Cleaning, Care And Maintenance - Polar Electro UA030 Instruction Manual

Operation

Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Do not place uncovered items as below inside
the appliance, as this can lead to a damaged
and leaking evaporator, and thus void your
warranty: hot food, hot liquids, acidic fluids,
acidic products.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods
of time.
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
To unlock / Lock the keyboard press
together for 3 seconds. Display will flash PON
(unlocked) / POF (locked).
Set the Operating Temperature
1. Press the SET button for 2 seconds. The value
of the set point will be displayed and the °C
LED starts blinking.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
UA030-UA031-UA032-UA033_ML_A5_v1_20240202.indb 5
and
buttons to display the
Manual Defrost
Press and hold the defrost button
to begin a manual defrost. The defrost light
illuminates.
The defrost cycle will end automatically.
Cleaning, Care &
Maintenance
Defrost appliance at least every 3
•
months, more often if required.
Switch off and disconnect from the power
•
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
• Take care when cleaning the rear of the
appliance. Sharp edges can cut.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount
of ice and internal/external condensation.
If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
EN
for 3 seconds
5
2024/2/2 16:32:16