Table of Contents
Advertisement
Telephone Helpline: 1300225960
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with water only.
•
Always wipe dry after cleaning.
•
A POLAR agent or qualified technician must carry out repairs if required.
•
If left unused for any length of time, store the appliance with the door ajar.
Auto Defrost
Periodically the appliance will run an automatic defrost cycle to prevent any ice build-up.
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
The appliance is
unusually loud
CE322-A_A5_v7_20181127.indb 5
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Too much ice on the condenser
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Appliance is overloaded
Loose nut/screw
The appliance has not been
installed in a level or stable
position
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
Defrost the appliance
Call POLAR agent or qualified Technician
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Reduce the amount of drinks stored in the
appliance
Check and tighten all nuts and screws
Check installation position and change if
necessary
AU
5
2018/11/27 10:28
Advertisement
Table of Contents
