Installation; Cleaning, Care And Maintenance; Operation - Polar Electro GD881 Instruction Manual

EN

Installation

Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water then dry well.
3. Set the brakes on the castors to keep the
appliance in position.

Operation

Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
Set the Operating Temperature
1. Press the SET button for 3 seconds. The
display will flash.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
4
GD881_ML_A5_v6_20231220.indb 4 GD881_ML_A5_v6_20231220.indb 4
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
The defrost cycle will end automatically.
Cleaning, Care &
Maintenance
•
•
•
•
•
•
•
Cleaning the Condenser
•
•
•
•
buttons to display the
Switch off and disconnect from the power
supply before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
The condenser is part of the refrigeration
system. The condenser requires monthly
cleaning.
Always disconnect power supply before
carrying out Routine Maintenance.
Failure to clean the condenser will reduce the
performance and life of your Polar unit and
may invalidate your warranty.
This model has a removable filter which can be
cleaned with a vacuum cleaner.
2023/12/20 16:53 2023/12/20 16:53