Table of Contents
Advertisement
Figure 31. Removing the intrusion switch
Next steps
1.
Replace the intrusion
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Align and insert the intrusion switch in the slot until it is firmly seated in the slot on the chassis.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Connect the intrusion switch cable to the connector on the system board.
Figure 32. Installing the intrusion switch
Next steps
1. Follow the procedure listed in
switch.
Safety
Before working inside your
After working inside your
instructions.
system.
system.
Installing and removing system components
35
Advertisement
Table of Contents
