Table of Contents
Advertisement
Next steps
1. Follow the procedure listed in
2. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Next steps
1.
Replace the expansion card
2. Follow the procedure that is listed in
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional optical drive
Removing the optical drive
The procedure for removing an optical drive and optical drive blank is the same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1. Disconnect the power and signal cables from the optical drive.
2. To release the optical drive, press the release tab and push the drive towards the front of the system.
50
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
riser.
System board jumpers and connectors
riser.
After working inside your
Safety
instructions.
Before working inside your
system.
Getting help
System board jumpers and connectors
system.
section.
system.
system.
section.
section.
Advertisement
Table of Contents
