Compaq Evo N150 Maintenance And Service Manual page 91

2. Disconnect the fan cable
(Figure 5-17).
3. Remove the modem cable from the clip in the heat sink
4. Remove the four black M2 × 4.0 screws
M2.5 × 7.0 screw
enclosure.
5. Remove the heat sink.
Figure 5-17. Removing the Heat Sink
The fan and heat sink are spared as one assembly. Do not remove


the fan from the heat sink.
Reverse the above procedure to install the heat sink.
Maintenance and Service Guide
Removal and Replacement Procedures
from the system board


that secure the heat sink to the base

and the pewter

.

5–25