Wireless Settings; Setting Master Unit's Flash Mode; Setting The Communication Channel; I-Ttl: Fully Automatic Wireless Flash Shooting - Godox TTL V860 II N Instruction Manual

Even with multiple slave units, the master unit can control
●
all of them via wireless.
In this user manual, "master unit" refers to the camera flash
●
on a camera and "slave unit" will be controlled by the
master unit.

1. Wireless Settings

You can switch between normal flash and wireless flash. For normal
flash shooting, be sure to set the wireless setting to OFF.
Master Unit Setting
Slave Unit Setting

2. Setting Master Unit's Flash Mode

3. Setting the Communication Channel

If there are other wireless flash systems nearby, you can change the
channel IDs to prevent signal interference. The channel IDs of the
master unit and the slave unit(s) must be set to the same.
- 41 -
Press < > button so that < >
is displayed on the LCD panel. If
< RPT> is displayed, it means
RPT mode is ON.
The backlight turns green now.
Press < > button again so that
< > and < > are
displayed on the LCD panel.
The backlight turns orange now.
1
Press Function Button 4
< > to choose the
Gr
group from M/A/B/C. Then,
press Function Button 3
< MODE > so that the
master unit can work in OFF
/ i-TTL / M flash mode.
Choose one of them as the
flash mode of master unit.
2
Press the "MODE/Lock
"button can change to RPT
mode.
1
Press Function Button 3
< > and turn the
CH
Select Dial to choose a
channel ID from 1 to 4.
2
Press the <SET> button to
confirm.
4. i-TTL：Fully Automatic Wireless Flash Shooting
Using Automatic Wireless Flash with a Single Slave Unit
The slave unit might be out of order or fire an unwanted flash due to the
nearby fluorescent lamp or computer screen.
●
If the slave unit's auto power off function is workable, press the master
unit's test button to power it on. Please note that test firing is unavailable
during the camera's regular metering time.
● The effective time of slave auto power off is changeable. (C.Fn-Sv APOT
Page 48)
● By making some settings, the auto AF-assist transmitter will not blink after
the slave unit's flash ready indicator is lightened. (C.Fn-AF Page 48)
1
Master Unit Setting
● Attach a V860IIN camera
flash on the camera and
set it as the master Unit.
(Page 41)
● M/A/B/C can be set as TTL
mode independently.
2
Slave Unit Setting
● Set the other camera flash
as the wireless slave Unit.
(Page 41)
● The slave unit can be set
as A/B/C.
3
Check the communication
channel.
● If the master unit and slave
unit(s) are set to a different
channel, set them to the
same channel. (Page 41)
4
Position the camera and
flashes.
● Position the camera and
flashes as the picture
shows. (Page 40)
5
Check that the flash is
ready.
● Check that the master flash
ready indicator is lightened.
● When the slave flash ready
indicator is ready, the AF-
assist beam lighting area
will blinks at 1 second
intervals.
6
Check the flash operation.
● Press the master unit's
Test Button < >.
● Then, the slave unit will
fire. If not, adjust the slave
unit's angle toward the
master unit and distance
from the master unit.
- 42 -