Table of Contents
Advertisement
Using Fully Automatic Wireless Flash
The FEC and other settings that set on the master unit will also be
appeared on the slave unit automatically. The slave unit does not
need any operation. Use the following settings to make wireless
flashes according to the same methods with normal flash shooting.
● Flash Exposure Compensation (
● High-Speed Sync (
SYNC
About Master Unit
Use two or more master units. By preparing several cameras that
with master units flash attached, cameras can be changed in
shooting while keeping the same lighting source (slave unit).
5. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
6. RPT: Wireless Flash Shooting with Manual Flash
The firing frequency of stroboscopic flash during the optic
transmission wireless shooting can be set from 1Hz to 100Hz
(settings from 250 Hz to 500 Hz are not available).
- 43 -
Page 36)
Page 37)
1
Setting the flash mode to
<M>.
● Press Function Button 4
<
> to choose groups.
Gr
Then, press Function
Button 3 <
MODE
> to set
the flash to M mode.
2
Setting flash output.
● Press Function Button 2
<
>. Turn the Select
Dial to set the flash output
of the groups. Press the
<SET> button to confirm.
3
Taking the picture.
● Each group fires at the set
flash ratio.
Setting < RPT > stroboscopic
flash.
● Press <MODE> button so that
<
RPT > is displayed.
● Setting the stroboscopic flash.
(Page 39)
Wireless Flash Shooting: Radio (2.4G) Transmission
Using a flash (master/slave) with a radio transmission wireless
shooting function make it easy to shoot with advanced wireless
multiple flash lighting, in the same way as i-TTL autoflash shooting.
The basic relative position and operation range are as shown in the
picture. You can then perform wireless i-TTL autoflash shooting just
by setting the master unit to <i-TTL>.
Positioning and Operation Range (Example of wireless flash
shooting)
● Autoflash Shooting with One Slave Unit
●
Use the supplied mini stand to position the slave unit.
●
Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on
the conditions such as positioning of slave units, the
surrounding environment and whether conditions.
Wireless Multiple Flash Shooting
You can divide the slave units into two or three groups and perform
i-TTL autoflash while changing the flash ratio (factor). In addition,
you can set and shoot with a different flash mode for each firing
group, for up to 5 groups.
● Auto Shooting with Two Slave Groups
A
B
Transmission distance is about 100m.
- 44 -
Advertisement
Table of Contents
