Table of Contents
Advertisement
Using Automatic Wireless Flash with Multiple Receiver Units
When stronger flash output or more
convenient lighting operation is needed,
increase the number of receiver units
and set it as a single receiver unit. To
add receiver units, use the same steps
as setting "using automatic wireless
flash with a single receiver unit". Any
flash group can be set (A/B/C/D/E).
When the number of receiver units
is increased or the transmitter unit
flash firing is ON, automatic control
is implemented to make all groups of
flashes fire the same flash output and
ensure the total flash output is up to
standard exposure.
Note：
1. If the receiver unit's auto power off function is on, press the transmitter unit's test
button to power it on. Please note that test firing is unavailable during the camera's
regular metering time.
2. By pressing the menu button to enter C.Fn setting, the effective time of receiver
unit's auto power off is changeable between 60min or 30min (RX STBY).
Using Fully Automatic Wireless Flash
The FEC and other settings that set on the transmitter unit will also be
appeared on the receiver unit automatically. The receiver unit does not need
any operation. Use the following settings to make wireless flash shooting
according to the same methods with normal flash shooting.
Flash Exposure Compensation
About Transmitter Unit
Use two or more transmitter units. By preparing several cameras that with
transmitter units attached, cameras can be changed in shooting while keeping
the same lighting source (receiver unit).
M: Wireless Flash Shooting with Manual Flash
Using wireless (multiple flash) shooting with manual flash, you can shoot
with a different flash output setting for each receiver unit (flash group) while
setting all parameters on the transmitter unit.
1. Set the Transmitter Unit's Flash Group to <M>
Press the wireless button and
the <
> icon is displayed on
the LCD panel, then the V1Pro S
attached to the camera is set as
the transmitter unit. Press the
corresponding function button
1/2/3/4<M/A/B/C > to make <M>
is displayed in all the flash groups
on the LCD panel.
40
2. Set the Flash Output of Each Flash Group
Press function button <M/A/B/C >
to choose a group. Turn the select
dial to set the flash output of the
group, then press the set button to
confirm.
3. Set the Wireless Channels of Transmitter Unit and Receiver Unit to the Same
For example, if the transmitter unit channel is set to 01, then the receiver
unit channel needs to be 01 as well.
4. Take Picture
Each receiver unit fires at the set flash ratio.
Multi: Wireless Flash Shooting with Manual Flash
1. Set the Transmitter Unit to Wireless Multi Flash
Press <MODE> mode button so
that <Multi> is displayed on the
LCD display, then press the wireless
button so that <Multi> and <
> are
displayed on the LCD display at the
same time.
2. Set the Flash Output, Number of Flashes and Flash Frequency of the
Wireless Multi Flash
Press <+/-> button to select flash
output of multi flash. Turn the select
dial to set the flash output amount,
then press the set button to confirm
the settings and exit.Press the set
button to select number of flashes of
flash frequency. Turn the select dial
to set the number of flashes of flash
frequency, then press the set button
to confirm the settings and exit.
3. Turn On/Off the Wireless Multi Flash of Receiver Unit Group
The wireless multi flash of receiver unit A/B/C can be turned on or off
directly on the transmitter unit.
4. Set the Receiver Unit
Press the wireless button to make the <Multi> and <RX> are displayed on
the LCD panel of the receiver unit.
5. Set the Wireless Channels of Transmitter Unit and Receiver Unit to the Same
For example, if the transmitter unit channel is set to 01, then the receiver
unit channel needs to be 01 as well.
Note：
The parameters of receiver unit can be directly set on the transmitter unit on the
condition that channels and IDs of them are set to the same.
41
Advertisement
Table of Contents
