Table of Contents
Advertisement
4-11 Changing the Power Distributor
The power distributor provides failover and power supply redundancy. In the unlikely
event that you must change the power distributor, do following:
Changing the Power Distributor
Power down the system, disconnect the power cords from the back of the power
supplies, lay the chassis on a flat surface, and open the chassis cover.
1. Remove all cable connections to the power supplies from the motherboard,
backplane, and other components. Also, remove both power supplies.
2. Locate the power distributor between the power supply and the fan row.
Power Supply
Figure 4-20. Removing the Power Distributor Cover
Power
Distributor
Cover
Chapter 4: Chassis Setup and Maintenance
Power Distributor Board
(Mounted in the tray on the
4-17
chassis wall)
Fan Row
Advertisement
Table of Contents
