PCB Piezotronics IMI SENSORS 683A1 Installation And Operating Manual page 17

STEP J Set Setpoint 3 (SP3) (No [doM] or [dob])
1) Using the
2) Press the
setting.
STEP K Set the Hysteresis Setting for Setpoint 3
1) Using the
value.
2) Press the
setting.
STEP L Set Setpoint 4 (SP4) (No [doM] or [dob])
1) Using the
2) Press the
STEP M Set the Hysteresis Setting for Setpoint 4
1) Using the
value.
2) Press the
setting.
STEP N Set Relay Activation mode [rLYS]
(h) High the relay energizes when the setpoint is exceeded. (L) Low the relay
energizes below the setpoint. The setpoint is indicated from left to right SP1, SP2, SP3,
SP4.
1) Using the
relay settings: [LLLL], [LhLh], [hLhL], [hhhh].
If only 2 relays installed [Lh--], [hL--], [hh--], [LL--].
2) Press the
operational display.
The Setpoint Relay programming mode is now complete.
and buttons, adjust the display to the desired SP3 value.
button. Display toggles between [hYST] and the previous [hYST]
and buttons, adjust the display to the desired hysteresis [hYST]
button. Display toggles between [SP4] and the previous [SP4]
and buttons, adjust the display to the desired SP4 value.
button. Display toggles between [hYST] and 0.
and buttons, adjust the display to the desired hysteresis [hYST]
button. Display toggles between [rLYS] and the previous relay
and buttons, adjust the reading on the display to the desired
button. The meter exits the setpoint mode and returns to the
PAGE 12