Table of Contents
Advertisement
Test Setup
2.3 Hardware Setup
Figure 2-2
shows the hardware setup of the LP8864EVM.
•
Connect a 12-V external power supply between the power input terminals VBAT+ and GNDin on the
LP8864EVM
•
Connect the USB2ANY module to the PC with the USB cable
•
Connect the USB2ANY module to the LP8864EVM with the provided ribbon cable
•
Connect the LP8864EVM to the LP886X-LEDLOAD-EVM with a 5-position ribbon cable
2.4 Software Installation
Download the GUI software from the
installation. Once installed, a shortcut to the GUI is found on the desktop and also in the start-up menu under the
Texas Instruments folder.
4
LP8864 Evaluation Module
Figure 2-2. LP8864EVM Hardware Setup
LP8864EVM tools
folder. Follow the instructions to finish the GUI
Copyright © 2020 Texas Instruments Incorporated
www.ti.com
SNVU731 – NOVEMBER 2020
Submit Document Feedback
Advertisement
Table of Contents
