Additional Gui Functions - Texas Instruments LP8864 User Manual

www.ti.com

2.6 Additional GUI Functions

In the selection tab on the left-hand side, the user can switch between LED Control, Monitor Faults, Diagnostics
and Register Map tabs. This section introduces GUI functions provided in the Monitor Faults, Diagnostics, and
Register Map tabs.
2.6.1 Monitor Faults Page
From the Monitor Faults page (see
be cleared by software by clicking the Clear All button. Fault interrupt can be enabled or disabled globally by
toggling the Interrupt All button. Besides that, each fault interrupt and each fault status can be controlled
individually.
SNVU731 – NOVEMBER 2020
Submit Document Feedback
Figure 2-6), the user has access to LP8864-Q1 fault status bits. Faults can
Figure 2-6. LP8864EVM Monitor Faults Page
Copyright © 2020 Texas Instruments Incorporated
Test Setup
LP8864 Evaluation Module 7