Power Connector - DFI WL051-BCC-B User Manual

Internal I/O Connectors
X

Power Connector

This 2-pin terminal block is considered a low power solution.
Connect a DC power cord to this terminal block by inserting the wire into the block and then
screw tight the screw on top to secure the wire in place. Please make sure the positive and
negative wires are installed correctly.
Using a voltage more than the recommended range may fail to boot the system or cause
damage to the system board.
User's Manual | WL051
„ 2-pin Power
Connector
1 (+): +12V
2 (-): GND
Chapter 2
HARDWARE INSTALLATION
20