Connect Batteries Continued - Chamberlain ELITE CSL24V Installation Manual

WIRING

CONNECT BATTERIES CONTINUED...

33AH BATTERIES
The batteries are charged in the circuit by the integrated transformer. The batteries
are for battery backup or solar installation. The 33AH application requires the 33AH
wire harness (Model K94-36596). NOTE: If 33AH batteries (2) are used, the battery
tray underneath the heater will need to be removed to allow more space in the
enclosure (if applicable).
1
Locate the J15 plug on the control board and disconnect it.
2
Connect the white jumper from the 33AH wire harness kit between the
positive (+) terminal of one battery and the negative (-) terminal of the
other battery.
3
Connect one end of the red (+) wire from the 33AH wire harness kit to the
red wire from the J15 plug as shown. Connect the other end of the red (+)
wire to the positive (+) terminal on the battery as shown.
4
Connect one end of the black (-) wire from the 33AH wire harness kit to the
black wire from the J15 plug as shown. Connect the other end of the black
(-) wire to the negative (-) terminal on the battery as shown.
5
Turn ON AC power to the operator.
6
Turn ON the AC power switch on the operator.
7
Reconnect the J15 plug to the control board. NOTE: You may see a small
spark when plugging the J15 plug into the board.
(without heater)
(with heater)
18
CONNECT BATTERIES
J15 Plug
Red (+) Black (-)
Red (+) wire
from new wire
harness kit
White jumper from
new wire harness kit
-
+ - +
33AH Batteries
Black (-) wire
from new wire
harness kit